Walbro FRC-6 Industrial Fuel Pump

Like the other pumps in the Walbro FR Series, the FRC-6 Industrial Fuel Pump features a die-cast aluminum body with a dichromate finish. It includes a removable, cleanable internal filter and runs continuously without cycling when power is applied to the pump. This pump is the replacement of choice for the old Walbro 6131, which has since been discontinued. Expect this pump to last over 10,000 hours under continuous use, and flow a minimum of 36 gallons per hour against a load of 4 to 6 psi. It has an impressive dry lift of 48", making it a good choice in locations where the pump must be installed high above the fuel level. See the other specifications below for more information.

All Walbro Marine and Industrial Fuel Pumps Feature:

• Low Current Draw
• Reverse-Polarity Protected up to 60 minutes
• Self-Priming (Dry Lift) of more than 48" (120 cm)
• Dry Run to Four Hours
• Compatible With All Commercially-Available Pump-Grade Gasoline, Gasohol, Diesel, or Bio-Diesel
• Operating Temperature from -40° to 155° Farenheit (-40° to 70° Celcius)
• Protection from Transient Voltages to 100 vdc
• US Coast Guard Approved (USCG 16623-1 and USCG 16623-2)
• European CE Standard Approved (EN 61000-6-2 and EN 63-2100)

Additionally, all Walbro FRC-Series Pumps Feature:

• Continuous Duty Life Over 10,000 Hours (Diesel Fuel)
• Weight of 1.83 lbs (0.83 Kg)
• Pump Cycles Continuously When Powered
• Replaceable Filter

Walbro FRC6 Pump Specifications:

Image of Mounting Flange and Included Components